United StatesChange

nVent CADDY Cat HP J-Hook with BC200 Beam Clamp, Swivel


  • Easy installation to beam flanges
  • Rotates 360 degrees to support various directional runs of cable
  • Provides optimal support for high-performance data cable, up to and including Cat 5e, Cat 6, Cat 6A, Cat 7 and fibre optic
  • Provides superior fill capacity and load rating over most other non-continuous cable support alternatives
  • Rounded edges on J-Hooks provide proper bend radius support for high performance data cables
  • Cost effective alternative to expensive cable tray
  • Complies with EN 50174-2
  • Meets ISO®/IEC 14763-2, ANSI®/TIA 568 and ANSI®/TIA 569


Material: Steel
Finish: Pregalvanized; Electrogalvanized
Part Number DiameterØ Area Cable Capacity, Cat 5e Cable Capacity, Cat 6 Cable Capacity, Cat 6A Flange ThicknessFT Static LoadF Certifications
CAT16HPBC200B 1" 1.07 in² 20 15 10 1/2" Max 60 lb cULus, E30, E60, E90
CAT21HPBC200B 1 5/16" 2.29 in² 50 40 25 1/2" Max 60 lb cULus
CAT32HPBC200B 2" 3.97 in² 90 60 35 1/2" Max 60 lb cULus, E30, E60, E90
CAT48HPBC200B 3" 9.26 in² 200 150 80 1/2" Max 60 lb cULus, E30, E60, E90
CAT64HPBC200B 4" 15.48 in² 330 220 140 1/2" Max 60 lb cULus, E30, E60, E90
Setscrew must be tightened and torqued onto the sloped side of the I-beam.
Non-continuous supports may not exceed spacing of 5' (1.5 m) per TIA 569-C.9.7 and EN 50174-2.
Cable capacity is calculated based on a 70% fill rate.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

ANSI is a registered trademark of American National Standards Institute.
ISO is a registered trademark of International Organization for Standardization.
UL, UR, cUL, cUR, cULus and cURus are registered certification marks of UL LLC.



3D Models