United StatesChange

SBC Stamped Beam Clamp, Top Mount


  • Allows structural attachment to metal beams, bar joist, channel, or angle iron in top mount position only unless used on a parallel flange
  • Lightweight, one-piece stamped body provides superior strength and eliminates deficiencies associated with castings
  • Spins onto threaded rod and allows for easy adjustment
  • Conforms with Federal Specification WW-H-171 (Type 23), Manufacturers Standardization Society ANSIĀ®/MSS-SP-58 (Type 19)


Material: Steel
Finish: Pregalvanized
Part Number Rod SizeRS Flange ThicknessFT A B C Screw DiameterSc TorqueTQ Static LoadF
SBC037 3/8" 3/4" Max 0.925" 0.85" 1.58" 3/8" 5 ft lb 500 lb
Set screw must be tightened and torqued onto the sloped side of the I-beam, channel, or angle iron flange.
Recognizing that torque wrenches are generally not used or available on many job sites, the setscrew should be tightened so it contacts the I-beam and then an additional 1/4 to 1/2 turn added.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

ANSI is a registered trademark of American National Standards Institute.
FM is a registered certification mark of FM Approvals LLC, LTD.
UL, UR, cUL, cUR, cULus and cURus are registered certification marks of UL LLC.