United StatesChange

nVent CADDY Cat HP J-Hook with Shot-Fire Bracket


  • Provides optimal support for high-performance data cable, up to and including Cat 5e, Cat 6, Cat 6A, Cat 7 and fibre optic
  • Complete with shot-fire bracket and pre-assembled drive pin from Powers Fasteners, Inc.
  • Quickly and easily attaches to concrete, steel or composite metal decking
  • Integrated pin installs easily using powder-actuated or single-shot gas-actuated tools
  • Rounded edges on J-Hooks provide proper bend radius support for high performance data cables
  • Provides superior fill capacity and load rating over most other non-continuous cable support alternatives
  • Complies with EN 50174-2
  • Meets ISO®/IEC 14763-2, ANSI®/TIA 568 and ANSI®/TIA 569
  • ICC-ES ESR-2024 evaluation report available for drive pin from Powers Fasteners, Inc


Material: Steel
Finish: Electrogalvanized; Pregalvanized
Part Number DiameterØ Area Cable Capacity, Cat 5e Cable Capacity, Cat 6 Cable Capacity, Cat 6A HeightH A Static LoadF
CAT16HPSF 1" 1.07 in² 20 15 10 4 3/4" 7/8" 60 lb
CAT21HPSF 1 5/16" 2.29 in² 50 40 25 5 1/8" 7/8" 60 lb
CAT32HPSF 2" 3.97 in² 90 60 35 5 1/2" 7/8" 60 lb
CAT48HPSF 3" 9.26 in² 200 150 80 7 1/4" 7/8" 60 lb
CAT64HPSF 4" 15.48 in² 330 220 140 8" 7/8" 60 lb
Uses Powers Fasteners, Inc. part number 50032.
Static load was established based on a 1” (25.4 mm) embedment depth and 3,000 psi (20.68 MPa) lightweight concrete. For variations in embedment and material please consult www.powers.com.
Pre-assembled drive pin from Powers Fasteners, Inc. works with Powers® C4CZ, Simpson® GCN-MEPKT, SPIT® P1000, P200, P2201, P3500 / PA3500, P35s, P45, P60, P7201, Sniper; Ramset® 721, Cobra, D45 / D60 / D60L, M70, SA270, T3SS, TS750P, TS60P, Viper; Hilti® DX35, DX350 / DX351 / DX36M, DX100 / DX200, DX460, DXA40, DXA41,​ DXE72 / DX400; Würth Diva-1, BST-1, BST-2 or equivalent nailers.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

ANSI is a registered trademark of American National Standards Institute.
HILTI is a registered trademark of Hilti Aktiengesellschaft.
ISO is a registered trademark of International Organization for Standardization.
Ramset is a registered trademark of Illinois Tool Works, Inc.
Simpson is a registered trademark of Simpson Strong-Tie Company Inc.
SPIT is a registered trademark of Societe De Prospection & D’Inventions Techniques Spit.



CADDY Direct Fastening
1.41 MB English

Engineering Specifications


Bend Radius Overview
588 KB English

3D Models