United StatesChange

Snap Close Conduit Clamp with Z Shot-Fire Bracket


  • Eliminates need for offset bending conduit
  • Finger closure, no tools required
  • Complete with shot-fire bracket and pre-assembled drive pin from Powers Fasteners, Inc.
  • Quickly and easily attaches to concrete, steel or composite metal decking
  • Integrated pin installs easily using powder-actuated or single-shot gas-actuated tools
  • ICC-ES ESR-2024 evaluation report available for drive pin from Powers Fasteners, Inc


Material: Steel; Spring Steel
Finish: Electrogalvanized; nVent CADDY Armour
Part Number Flexible Conduit Size MC/AC Cable Size EMT Conduit Size Rigid Conduit/Pipe Size Outer DiameterOD HeightH WidthW A Static LoadF
6MZSF 3/8" 14-2 to 12-3 0.55" – 0.70" 3 1/2" 2 1/2" 7/8" 100 lb
812MZSF 1/2", 3/4" 1/2", 3/4" 0.70" – 1.18" 3 7/8" 2 3/4" 7/8" 100 lb
16MZSF 1" 1" 1.18" – 1.38" 4 3/8" 2 3/4" 7/8" 100 lb
Uses Powers Fasteners, Inc. part number 50032.
Static load was established based on a 1” (25.4 mm) embedment depth and 3,000 psi (20.68 MPa) lightweight concrete. For variations in embedment and material please consult www.powers.com.
Pre-assembled drive pin from Powers Fasteners, Inc. works with Powers® C4CZ, Simpson® GCN-MEPKT, SPIT® P1000, P200, P2201, P3500 / PA3500, P35s, P45, P60, P7201, Sniper; Ramset® 721, Cobra, D45 / D60 / D60L, M70, SA270, T3SS, TS750P, TS60P, Viper; Hilti® DX35, DX350 / DX351 / DX36M, DX100 / DX200, DX460, DXA40, DXA41,​ DXE72 / DX400; Würth Diva-1, BST-1, BST-2 or equivalent nailers.
For shot-fired supports in seismic design category D, E, or F, maximum load is the lesser of 90 lb (400 N) or the published load.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

HILTI is a registered trademark of Hilti Aktiengesellschaft.
Ramset is a registered trademark of Illinois Tool Works, Inc.
Simpson is a registered trademark of Simpson Strong-Tie Company Inc.
SPIT is a registered trademark of Societe De Prospection & D’Inventions Techniques Spit.



3D Models