United StatesChange

BC26 Universal Beam Clamp with Tapped Hole


  • One thru-hole for easier installation of threaded rod
  • Conforms with Federal Specification WW-H-171 (Type 23), Manufacturers Standardization Society ANSIĀ®/MSS-SP-58 (Type 19 and 23)


Material: Cast Iron
Finish: Electrogalvanized
Part Number Rod SizeRS Flange ThicknessFT A Hole SizeHS Hole Type Screw DiameterSc TorqueTQ Static Load 1F1 Static Load 2F2
BC260025EG 1/4" 13/16" Max 13/16" 1/4" Threaded 1/4" 4 ft lb 250 lb 100 lb
Setscrew must be tightened and torqued onto the sloped side of the I-beam.
Recognizing that torque wrenches are generally not used or available on many job sites, the setscrew should be tightened so it contacts the I-beam and then an additional 1/4 to 1/2 turn added.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

ANSI is a registered trademark of American National Standards Institute.