United StatesChange

nVent CADDY Cat HP Double J-Hook with BC200 Beam Clamp, Swivel



  • Low-profile configuration providing double J-Hook capacity
  • Easy installation to beam flanges
  • Rotates 360 degrees to support various directional runs of cable
  • Provides optimal support for high-performance data cable, up to and including Cat 5e, Cat 6, Cat 6A, Cat 7 and fibre optic
  • Provides superior fill capacity and load rating over most other non-continuous cable support alternatives
  • Rounded edges on J-Hooks provide proper bend radius support for high performance data cables
  • Cost effective alternative to expensive cable tray
  • Complies with EN 50174-2
  • Meets ISO®/IEC 14763-2, ANSI®/TIA 568 and ANSI®/TIA 569


Part Number CAT48HPD1BC2
Material Steel
Finish Pregalvanized
Diameter (Ø) 3"
Flange Thickness (FT) 1/2" Max
Width (W) 8 1/2"
A 6 3/4"
Static Load (F) 100 lb
Standard Packaging Quantity 10 pc
UPC 78285686556
Static load limit of each J-Hook is 60 lb (270 N).
Setscrew must be tightened and torqued onto the sloped side of the I-beam.
Non-continuous supports may not exceed spacing of 5' (1.5 m) per TIA 569-C.9.7 and EN 50174-2.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

ANSI is a registered trademark of American National Standards Institute.
ISO is a registered trademark of International Organization for Standardization.