Bolt Close Conduit/Pipe Clamp with Z Shot-Fire Bracket

CD0BZSF

Details
Applications
Video
Documents
3D Models

PDF Version

Features

Retained bolt and built-in nut means there are less parts to handle or drop
Combo head bolt works with slotted, hex, #3 phillips or #2 robertson drivers
Complete with shot-fire bracket and pre-assembled drive pin from Powers Fasteners, Inc.
Quickly and easily attaches to concrete, steel or composite metal decking
Integrated pin installs easily using powder-actuated or single-shot gas-actuated tools
ICC-ES ESR-2024 evaluation report available for drive pin from Powers Fasteners, Inc

Specifications

Part Number	CD0BZSF
Material	Steel
Finish	Electrogalvanized
Outer Diameter (OD)	0.67" – 0.84"
EMT Conduit Size	1/2"
Rigid Conduit/Pipe Size	1/2"
Height (H)	3 7/8"
Width (W)	2 3/4"
A	7/8"
Static Load (F)	100 lb
Standard Packaging Quantity	50 pc
UPC	78285686633
EAN-13	0782856866336

Uses Powers Fasteners, Inc. part number 50032.

Static load was established based on a 1” (25.4 mm) embedment depth and 3,000 psi (20.68 MPa) lightweight concrete. For variations in embedment and material please consult www.powers.com.

Pre-assembled drive pin from Powers Fasteners, Inc. works with Powers® C4CZ, Simpson® GCN-MEPKT, SPIT® P1000, P200, P2201, P3500 / PA3500, P35s, P45, P60, P7201, Sniper; Ramset® 721, Cobra, D45 / D60 / D60L, M70, SA270, T3SS, TS750P, TS60P, Viper; Hilti® DX35, DX350 / DX351 / DX36M, DX100 / DX200, DX460, DXA40, DXA41, DXE72 / DX400; Würth Diva-1, BST-1, BST-2 or equivalent nailers.

For shot-fired supports in seismic design category D, E, or F, maximum load is the lesser of 90 lb (400 N) or the published load.

nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX, and nVent LENTON are owned by nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.

HILTI is a registered trademark of Hilti Aktiengesellschaft.

Ramset is a registered trademark of Illinois Tool Works, Inc.

Simpson is a registered trademark of Simpson Strong-Tie Company Inc.

SPIT is a registered trademark of Societe De Prospection & D’Inventions Techniques Spit.

Warning

WARNING
nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death and/or void your warranty.