United StatesChange

T-Series Horizontal Sleeve, Side Fill


The side fill horizontal T-Series sleeve has vent holes located 90 degrees from the tap hole to facilitate side fill installations when the interferences of the structure will not allow top filling. Vent holes are added to horizontal sleeves to reduce air entrapment and help ensure proper filling of the sleeve.


  • Designed to connect horizontal reinforcing bars and angular reinforcing bars up to 45 degrees
  • Used to splice the same diameter bars
  • Works with saw cut, flame cut and sheared bars
  • Can be visually inspected after installation
  • Available with extended sleeve lengths


Part Number RBT7101HSA
Material Steel
Finish Plain
100% U.S. Domestic Content Yes
Sleeve Standard Length
Rebar Size, Metric 22 mm
Rebar Size, US #7
Diameter 1 (Ø1) 1.63"
Diameter 2 (Ø2) 1.13"
Length 1 (L1) 5"
Length 2 (L2) 2.5"
Length 3 (L3) 0.78"
Unit Weight 1.5 lb
Designed to Meet AASHTO
ABNT NBR 8548:1984
ACI 318 Type 1 (125% Specified Yield)
ACI 318 Type 2 (Specified Ultimate)
ACI 349
ACI 359
CAN/CSA - N287.2/.3/.4
IBC Type 1 (125% Specified Yield)
IBC Type 2 (Specified Ultimate)
US Army Corps of Engineers
Standard Packaging Quantity 36 pc
UPC 78285669321
Prior to installation, please read and understand all of the detailed instructions and safety notices provided in the LENTON CADWELD Rebar Splicing System Instruction Manual.
Sizes not shown may be available by special order. Contact your LENTON representative for more information.

Pentair, CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are owned by Pentair or its global affiliates. All other trademarks are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.