The top fill, low slip horizontal T-Series sleeve length is increased to reduce slip (for extreme code requirements) and when the rib pattern or spacing does not meet the minimum product specifications.
Vent holes are added to horizontal sleeves to reduce air entrapment and help ensure proper filling of the sleeve.
- Designed to connect horizontal reinforcing bars and angular reinforcing bars up to 45 degrees
- Used to splice the same diameter bars
- Additional length improves performance
- Works with saw cut, flame cut and sheared bars
- Can be visually inspected after installation
|100% U.S. Domestic Content
|Rebar Size, Metric
|Rebar Size, US
|Diameter 1 (Ø1)
|Diameter 2 (Ø2)
|Length 1 (L1)
|Length 2 (L2)
|Length 3 (L3)
|Designed to Meet
ABNT NBR 8548:1984
ACI 318 Type 1 (125% Specified Yield)
ACI 318 Type 2 (Specified Ultimate)
CAN/CSA - N287.2/.3/.4
IBC Type 1 (125% Specified Yield)
IBC Type 2 (Specified Ultimate)
US Army Corps of Engineers
|Standard Packaging Quantity
Pentair, CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are owned by Pentair or its global affiliates. All other trademarks are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
Pentair products shall be installed and used only as indicated in Pentair's product instruction sheets and training materials. Instruction sheets are available at www.erico.pentair.com and from your Pentair customer service representative. Improper installation, misuse, misapplication or other failure to completely follow Pentair's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death and/or void your warranty.