United StatesChange

T-Series Horizontal Low Slip Sleeve, Top Fill


The top fill, low slip horizontal T-Series sleeve length is increased to reduce slip (for extreme code requirements) and when the rib pattern or spacing does not meet the minimum product specifications.

Vent holes are added to horizontal sleeves to reduce air entrapment and help ensure proper filling of the sleeve.


  • Designed to connect horizontal reinforcing bars and angular reinforcing bars up to 45 degrees
  • Used to splice the same diameter bars
  • Additional length improves performance
  • Works with saw cut, flame cut and sheared bars
  • Can be visually inspected after installation


Part Number RBW6559HA
Material Steel
Finish Plain
100% U.S. Domestic Content Yes
Rebar Size, Metric 28 mm
Rebar Size, US #9
Rebar Size, Canada 30M
Diameter 1 (Ø1) 2.13"
Diameter 2 (Ø2) 1.5"
Length 1 (L1) 7"
Length 2 (L2) 3.5"
Length 3 (L3) 0.78"
Unit Weight 3.5 lb
Designed to Meet AASHTO
ABNT NBR 8548:1984
ACI 318 Type 1 (125% Specified Yield)
ACI 318 Type 2 (Specified Ultimate)
ACI 349
ACI 359
CAN/CSA - N287.2/.3/.4
IBC Type 1 (125% Specified Yield)
IBC Type 2 (Specified Ultimate)
US Army Corps of Engineers
Standard Packaging Quantity 16 pc
UPC 78285641974
Prior to installation, please read and understand all of the detailed instructions and safety notices provided in the LENTON CADWELD Rebar Splicing System Instruction Manual.
Sizes not shown may be available by special order. Contact your LENTON representative for more information.

Pentair, CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are owned by Pentair or its global affiliates. All other trademarks are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.